哪个IS-IS命令提供了已连接路由器的信息?()
A.show isis interface
B.show isis adjacency
C.show isis statistics
D.show isis neighbo
A.show isis interface
B.show isis adjacency
C.show isis statistics
D.show isis neighbo
A.show isis database detail
B.show isis interface
C.show isis route
D.show isis statistics
A.show isis database
B.show isis route
C.show route protocol isis
D.show isis adjacency
A.IntegratedIS-IS使用L3路由作为骨干路由
B.骨干网是一个连续的L2或L1/L2ISIS路由器的链条
C.IntegratedISIS路由器属于至少一个area,不需要中央化的骨干area
D.所有的ISIS其他area都必须连集中接到ISIS的骨干area上
A.从路由器 C Ping 路由器 B 的 S0/1 连接
B.跟踪路由器 B 与路由器 C S0/1 之间的连接
C.在路由器 B 上发出 show ip route 命令,检验是否已启用路由
D.在路由器 C 上发出 show interfaces 命令
A.让路由器进入ROM监视器模式
B.提供了密码恢复功能
C.让路由器在NVRAM中查找boot命令
D.从TFTP服务器加载IOS
E.加载存储在ROM中的IOS映像
Cisco路由器用于查看路由表信息的命令是()。
A.showiproute
B.showiprouter
C.showroute
D.showrouter
路由器命令R1(config)# ip routing的作用是(61)。
A.显示路由信息
B.配置默认路由
C.激活路由器端口
D.启动路由配置
路由器命令 R1(config)in prouting 的作用是()。
A.显示路由信息
B.配置默认路由
C.激活路由器端口
D.启动路由配置